Editor – Device Page
Although Ferguson Beauregard Auto-Cycle Plus and SFC are not Modbus devices, the EIE contains a data group ("FCU Modbus Setup") that allows basic process variables to be passed through to another flow control device. This operation requires that you select a device type and Modbus address, define the data and registers, and set up Modbus communication options. This information is read only and must be configured on the device during device installation.
Another feature of this EIE is its support for gas flow data and calculations using the "Gas Measurement Config" data group. The Auto-Cycle Plus device is not intrinsically configured to provide gas flow data, so CygNet developed a data group that extracts the required data and performs gas flow calculations with it.
The following table lists and describes EIE specifications.
| Manufacturer | Ferguson Beauregard |
|
Protocol(s) |
FB Net |
|
Model(s) |
Auto-Cycle Plus (TD, V4 RTU5000, and V5) CBM-POD CBM-WellHead (RTU5000 and TD) SFC |
|
Required Files |
CxDdsFbNetEditors.dll UisFbNetDrivers.dll |
|
Sample Templates |
FbNet_ACP_TD.dtf FbNet_ACP_V4_RTU5000.dtf FbNet_ACP_V5.dtf FbNet_CBM_Pod.dtf FbNet_CBM_WellHead_RTU5000.dtf FbNet_CBM_WellHead_TD.dtf FbNet_SFC.dtf |
|
Cryout Support |
No |
|
FMS Support |
No for SFC Yes, for all models except SFC, using FMS Legacy EFM data items Note: In cases where only GMR support was previously available, CygNet Measurement now provides equivalent data support using FMS Legacy data items. If you were previously using GMR data items, you must update to use FMS Legacy data items. Update options are provided as part of your software upgrade procedure. See the CygNet Upgrade Procedure for more information. |
|
Listen Mode |
No |
|
64-bit Support |
Yes. See 64-bit Device Drivers. |
For more information, see sample device template files and manufacturer documentation.
More:
UIS Command Component Parameters
FMS Legacy Configuration Data Group
FMS Legacy Config Send Data Group
|
|
|
